Flat Face Pulley
with Double Groove
32’s of Inch
32’s of Inch
|PUL01||_ _||_||_ _ _||_ _||_ _||_||_ _||_||_||_ _ _ _|
Example Above: Face face pulley with two Grooves, PVC material, machined smooth face, 3-1/2″ OD, 10.00″ long, 1.00″ bore with Keyway and Set Screws and “A” section “V” groove located 1″ from each end of the pulley to center-line of groove.
|PV||Code for PVC||UH||Code for UHMW|
|4S||Code for Stainless Steel||**||Other materials available on request|
|K||Code for Knurled Face||S||Code for Machined Smooth Face|
OD Codes (outside diameter)
|129 = code for 1.90″OD||228 = code for 2-7/8″OD||400 = code for 4″OD||616 = code for 6-1/2″OD|
|212 = code for 2-3/8″OD||316 = code for 3-1/2″OD||416 – code for 4-1/2″OD||818 = code for 8-1/2″OD|
Bore and Length Codes
|08 = code for 1/4″||14 = code for 7/16″||20 = code for 5/8″||26 = code for 13/16″|
|10 = code for 5/16″||16 = code for 1/2″||22 = code for 11/16″||28 = code for 7/8″|
|12 = code for 3/8″||18 = code for 9/16″||24 = code for 3/4″||30 = code for 15/16″|
First two digits of length code is whole inches.
Second two digits of length code is based on 32’s of an inch increments.
( Example: Length is 15-1/2” = 1516 )
|A = Keyway & Set Screws||B = Set Screws||C = UHMW Journal Bearings||D = Machined for Press Fit of ball bearing||E = Special – Need Detail of special|